TunerCodeSA firmware is the program that runs on the ECU which implements all of the tuning parameters and features in the TCD programmable with the NismotronicSA software.

• FUEL TABLE Tab
  • MAF Load Fuel Table
  • MAP Load Fuel Table
• IGNITION TABLE Tab
  • Ignition Timing Operation
• FUEL TRIMS Tab
  • INJECTORS
  • CRANKING
  • POST START
  • ECT CORRECTIONS
  • IAT CORRECTIONS
  • BOOST COMP
  • BARO CORRECTIONS
  • KNOCK ENRICHMENT
  • CYLINDER FUEL TRIMS
• IGNITION TRIMS Tab
  • IGNITION TRIMS
  • COIL DWELL
  • KNOCK
  • ACCEL IGNITION TRIM
  • CYLINDER IGNITION TRIMS
  • CRANKING IGNITION
• BOOST CONTROL Tab
  • EBC SETUP
  • BOOST BY GEAR
  • IAT DUTY COMP
  • OVER BOOST
• LIMITERS Tab
  • REV LIMIT SETUP
  • OTHER REV LIMIT
  • FULL THROTTLE SHIFT
• OUTPUTS Tab
  • NITROUS OUTPUT SETUP
  • MAP SWITCHING
  • MIL WARNING INDICATOR
  • GENERIC OUTPUTS
  • A/C CONTROL
  • STOCK OUTPUTS
• ACCEL/DECEL Tab
  • ASYNCHRONOUS ACCEL ENRICHMENT
  • SYNCHRONOUS ACCEL ENRICHMENT
  • DECEL FUEL REDUCTION
  • OVERRUN FUEL CUT
• CLOSED LOOP Tab
  • CLOSED LOOP PARAMETERS
  • WIDEBAND CLOSED LOOP
• IDLE Tab
  • BASE IDLE
  • IDLE RECOVERY
  • IDLE ERROR
  • IDLE IGNITION TIMING
  • THROTTLE OPEN IDLE DUTY
• SETUP Tab
  • LOAD SOURCE
  • MAP SENSOR
  • WIDEBAND O2 SENSOR
  • IAT SENSOR
  • ECT SENSOR
  • THROTTLE POSITION SENSOR
  • BARO SENSOR
  • MAF|MAP FILTERING
  • DIAGNOSTICS
  • MAF SENSOR
  • FLEX FUEL SETUP

• Cranking Mode Description
• Idle RPM Control
• IAT Density Correction
• Knock System Description
• Launch Control
• Anti-Lag
• Full Throttle Shift
• Output Programming
• Alternate Injector Size
• Target AFR Table
• Fuel Pumpout Control
• Gear Parameters
• Flex Fuel